Pin 4 used here for consistency with other Arduino examplesĢ015: included SPI.h and made SPI bus idle. ** CS - depends on your SD card shield or module.
** CLK - pin 13 on Arduino Uno/Duemilanove/Diecimila ** MISO - pin 12 on Arduino Uno/Duemilanove/Diecimila ** MOSI - pin 11 on Arduino Uno/Duemilanove/Diecimila * SD card attached to SPI bus as follows: Very useful for testing a card when you're not sure whether its working or not. SD library is based in order to get info about your SD card. NOTE: A drive must be at least 512 megabytes (MB) in size to be converted to the FAT32 file system.This example shows how use the utility libraries on which the' When the conversion is complete, click Finish.Īt a command prompt, type cvt drive: /cvt32 and then press ENTER, where drive is the drive you want to convert to the FAT32 file system.įor more information about the FAT32 file system, see the following article in the Microsoft Knowledge Base:ġ54997 Description of the FAT32 File System In the Drives box, click the drive you want to convert to the FAT32 file system.Ĭlick Next, click Next, and then click Next again. NOTE: Before you convert to the FAT32 file system, uninstall any utilities or tools that protect or encrypt the Master Boot Record (MBR) or partition table (for example, uninstall Bootlock included with Symantec Norton Your Eyes Only).Ĭlick Start, point to Programs, point to Accessories, point to System Tools, click Drive Converter (FAT32), and then click Next. To convert a drive to the FAT32 file system, use the following steps.
Also, this procedure does not work if your hard disk has bad sectors.
WARNING: After you convert your hard disk to FAT32, you are unable to convert it back to the original FAT system. This article describes how to convert a hard disk that uses the File Allocation Table (FAT or FAT16) file system to the FAT32 file system using Drive Converter.
0 kommentar(er)
